FUJITSU PRIMERGY BX600 - Manual (Page 239)

Security Commands Command Reference
Intelligent Blade Panel Module
238
dot1x max-req <1-10>
no dot1x max-req
<1-10> -
maximum number of times (Range: 1 – 10).
no -
This command sets the maximum number of times the authenticator state machine
on this port will transmit an EAPOL EAP Request/Identity frame before timing out the
supplicant to the default value, that is, 2.
Default Setting
2
Command Mode
Interface Config
7.9.3.8 dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
Syntax
dot1x re-authentication
no dot1x re-authentication
no - This command disables re-authentication of the supplicant for the specified port.
Default Setting
Disabled
Command Mode
Interface Config
7.9.3.9 dot1x re-reauthenticate
This command begins the re-authentication sequence on the specified port. This command is
only valid if the control mode for the specified port is 'auto'. If the control mode is not 'auto' an
error will be returned.