FUJITSU PRIMERGY BX600 - Manual (Page 143)

Device Configuration Commands Command Reference
Intelligent Blade Panel Module
142
all - This command displays statistics information for all interfaces.
Default Setting
None
Command Mode
Privileged Exec
Display Message
The display parameters when the argument is '' are as follows:
Packets Received Without Error:
The total number of packets (including broadcast
packets and multicast packets) received by the processor.
Packets Received With Error:
The number of inbound packets that contained errors
preventing them from being deliverable to a higher-layer protocol.
Broadcast Packets Received:
The total number of packets received that were directed to
the broadcast address. Note that this does not include multicast packets.
Packets Transmitted Without Error:
The total number of packets transmitted out of the
interface.
Transmit Packets Errors:
The number of outbound packets that could not be transmitted
because of errors.
Collisions Frames:
The best estimate of the total number of collisions on this Ethernet
segment.
Time Since Counters Last Cleared:
The elapsed time, in days, hours, minutes, and
seconds since the statistics for this port were last cleared.
The display parameters when the argument is 'all' are as follows:
Interface:
The physical slot and physical port or the logical slot and logical port.
Summary: The summation of the statistics of all ports.
Packets Received Without Error:
The total number of packets (including broadcast
packets and multicast packets) received.
Packets Received With Error:
The number of inbound packets that contained errors
preventing them from being deliverable to a higher-layer protocol.
Broadcast Packets Received:
The total number of packets received that were directed to
the broadcast address. Note that this does not include multicast packets.
Packets Transmitted Without Error:
The total number of packets transmitted.
Transmit Packets Errors: The number of outbound packets that could not be transmitted
because of errors.
Collisions Frames:
The best estimate of the total number of collisions on this Ethernet
segment.
This command displays detailed statistics for a specific port or for all CPU traffic based upon
the argument.