FUJITSU PRIMERGY BX600 - Manual (Page 200)

Management Commands Command Reference
Intelligent Blade Panel Module
199
7.5.6.3 ip http port
This command is used to set the http port where port can be 1-65535 and the default is port 80.
Syntax
ip http port <1-65535>
no ip http port
<1-65535> - HTTP Port value.
no - This command is used to reset the http port to the default value.
Default Setting
80
Command Mode
Global Config
7.5.6.4 ip http server
This command enables access to the IBP through the Web interface. When access is enabled,
the user can login to the IBP from the Web interface. When access is disabled, the user cannot
login to the IBP's Web server.
Disabling the Web interface takes effect immediately. All interfaces are affected.
Syntax
ip http server
no ip http server
no - This command disables access to the IBP through the Web interface. When access is
disabled, the user cannot login to the IBP's Web server.
Default Setting
Enabled