FUJITSU PRIMERGY BX600 - Manual (Page 205)

Management Commands Command Reference
Intelligent Blade Panel Module
204
Syntax
ip ssh timeout <1-160>
no ip ssh timeout
<1-160> - timeout interval in seconds.
no - This command sets the SSH connection session timeout value, in minutes, to the
default. Changing the timeout value for active sessions does not become effective until the
session is reaccessed. Any keystroke will also activate the new timeout duration.
Default Setting
5
Command Mode
Global Config
7.5.8 DHCP Client Commands
7.5.8.1 ip dhcp restart
This command is used to initiate a BOOTP or DCHP client request.
Syntax
ip dhcp restart
Default Setting
None
Command Mode
Global Config
7.5.8.2 ip dhcp client-identifier
This command is used to specify the DCHP client identifier for this IBP. Use the no form to
restore to default value.