FUJITSU PRIMERGY BX600 - Manual (Page 185)

Management Commands Command Reference
Intelligent Blade Panel Module
184
Syntax
sessions
no sessions
no - This command disables telnet sessions. If sessions are disabled, no new telnet
sessions are established.
Default Setting
Enabled
Command Mode
Telnet Config
7.5.3.8 telnet sessions
This command regulates new outbound telnet connections. If enabled, new outbound telnet
sessions can be established until it reaches the maximum number of simultaneous outbound
telnet sessions allowed. If disabled, no new outbound telnet session can be established. An
established session remains active until the session is ended or an abnormal network error
ends it.
Syntax
telnet sessions
no telnet sessions
no - This command disables new outbound telnet connections. If disabled, no new
outbound telnet connection can be established.
Default Setting
Enabled
Command Mode
Global Config
7.5.3.9 telnet maxsessions