FUJITSU PRIMERGY BX600 - Manual (Page 255)

SNTP Commands Command Reference
Intelligent Blade Panel Module
254
Command Mode
Global Config
7.10.2.3 sntp client port
This command will set the SNTP client port id and polling interval in seconds.
Syntax
sntp client port [<6-10>]
no sntp client port
- SNTP client port id.
<6-10> - Polling interval. It's 2^(value) seconds where value is 6 to 10.
no -
Resets the SNTP client port id.
Default Setting
The default portid is 123.
Command Mode
Global Config
7.10.2.4 sntp unicast client poll-interval
This command will set the poll interval for SNTP unicast clients in seconds.
Syntax
sntp unicast client poll-interval <6-10>
no sntp unicast client poll-interval
<6-10> - Polling interval. It's 2^(value) seconds where value is 6 to 10.
no -
This command will reset the poll interval for SNTP unicast clients to its default value.