About fortinet discovery protocol, Routing, Dns routing – Fortinet FortiAnalyzer 3.0 MR7 User Manual
Page 46: About fortinet
FortiAnalyzer Version 3.0 MR7 Administration Guide
46
05-30007-0082-20080908
Network
System
About Fortinet Discovery Protocol
FortiGate units running FortiOS version 3.0 or greater can use Fortinet Discovery
Protocol (FDP), a UDP protocol, to locate a FortiAnalyzer unit.
When a FortiGate administrator selects Automatic Discovery, the FortiGate unit
attempts to locate FortiAnalyzer units on the network within the same subnet. If
FDP has been enabled for its interface to that subnet, the FortiAnalyzer unit will
respond. Once the FortiGate unit discovers a FortiAnalyzer unit, the FortiGate unit
automatically enables logging to the FortiAnalyzer and begins sending log data.
Depending on its configuration, the FortiAnalyzer unit may then automatically
register the device and save its data, add the device but ignore its data, or ignore
the device entirely. For more information, see
“Configuring unregistered device
connection attempt handling” on page 79
DNS
Configure primary and secondary DNS servers to provide name resolution
required by FortiAnalyzer features such as NFS shares.
To configure DNS settings
1
Go to System > Network > DNS.
2
Enter an IP address for a primary and secondary DNS server.
3
Select Apply.
Routing
The route list displays the static routes on the FortiAnalyzer unit.
To view the routing list, go to System > Network > Routing.
Figure 22: Route list
Note: Configure and verify your DNS settings. Incorrect DNS settings can cause other
features.
Primary DNS Server
Enter the primary DNS server IP address.
Secondary DNS
Server
Enter a secondary DNS server IP address.
Destination
IP/Netmask
The destination IP address and netmask of packets that the
FortiAnalyzer unit wants to send to.
Gateway
The IP address of the router where the FortiAnalyzer unit forwards
packets.
Interface
The names of the FortiAnalyzer interfaces through which
intercepted packets are received and sent.
Modify
Select to change the route configuration.
Create New
Add a route to the route list.