Network, Interface – Fortinet FortiAnalyzer 3.0 MR7 User Manual
Page 44
FortiAnalyzer Version 3.0 MR7 Administration Guide
44
05-30007-0082-20080908
Network
System
3
Enter the appropriate information for the following:
4
Select OK.
Network
Use the network settings to configure the FortiAnalyzer unit to operate in your
network. Basic network settings include configuring interfaces, DNS settings and
static routes.
Interface
You can configure the interfaces on the FortiAnalyzer unit, including their IP
address, and permitted remote administration protocols.
Figure 21: Interface list
Device
Select the registered device or device group from the drop-down
list.
Display by
Select one of the following to filter the information:
•
Top Sources (to any) – filters only the top sources
•
Top Destinations (from any) – filters only the top destinations
•
Top Source and Destination (unique) – filters the top sources
to unique destinations
FIlter Source IP
Address
Enter the source IP address.
Filter Destination IP
Address
Enter the destination IP address.
Time Scope
Select one of the following for the time range:
•
Hour – filters the time by hour
•
Day – filters the time by the current day
•
Week – filters the time by the current week
•
Month – filters the time by the current month
No. Entries
Select the number of entries to display. For example, if you want
to display 10 entries, select 10 from the drop-down list. You can
specify only 5, 10, or 20.
Name
The name of the network interface on the FortiAnalyzer unit.
IP/Netmask
The IP address and network mask configured for the interface.
Access
A list of the administrative access methods available on the
interface. For more information, see
.
FDP
Fortinet Discovery Protocol (FDP) indicator. When Fortinet
Discovery Protocol is enabled for an interface, a green check
appears. For more information about FDP, see
Discovery Protocol” on page 47
and
unit using the Fortinet Discovery Protocol (FDP)” on page 85