Fortinet FortiAnalyzer 3.0 MR7 - Manual (Page 148)

FortiAnalyzer Version 3.0 MR7 Administration Guide
140 05-30007-0082-20080908
Output Alert
RFC-1213 (MIB II)
• mib-2.system
• mib-2.interface
• mib-2.at
• mib-2.ip
• mib-2.icmp
• mib-2.tcp
• mib-2.udp
• mib-2.ifMIB
RFC-2665 (Ethernet-like MIB)
• .dot3StatsTable
• .dot3CollTable
• .dot3ControlTable
• .dot3PauseTable
Configuring alerts by Syslog server
You can configure Syslog servers where the FortiAnalyzer unit can send
alerts.You must add the syslog server before you can select it as a way for the
FortiAnalyzer unit to communicate an alert.
To view the SNMP servers, go to Alert > Output > Syslog Server.
Figure 4: Syslog server list
Adding a Syslog server
You can add a Syslog server to send alerts by the Syslog protocol.
To add a new Syslog server
1 Go to Alert > Output > Syslog Server.
2 Select Create New.
Create New Select to add a new Syslog server.
Name The name given to the Syslog server.
IP or FQDN: Port The IP address or fully qualified domain name for the SNMP
server, and port number.
Action Select Delete to remove the Syslog server configuration.
Select Edit to change the Syslog server configuration.
Select Test to verify the Syslog server configuration.
Delete
Edit
Test