ATN TITEW1000 Thermal Entry Wizard Access Control Station with Table Stand Mount - Manual (Page 8)

14 15
6 . Use 2 supplied screws (SC-M4 × 14 .5TP10-SUS) to secure the device and
the mounting plate .
NOTE
When the screw’s head is beneath the device surface, the device is
secured.
Figure 3-3. Secure Device
NOTE
The installation height here is the recommended height. You can
change it according to your actual needs.
For easy installation, drill holes on mounting surface according to the
supplied mounting template.
3.3. SURFACE MOUNTING
Steps
1 . According to the datum line on the mounting template, stick the mounting
template on the wall or other surface, 1 .4 meters higher than the ground .
2 . Drill 5 holes on the wall or other surface according to the mounting tem-
plate .
Figure 3-4. Mounting Template
3 . Insert the screw sockets of the setscrews in the drilled holes .
Figure 3-5. Insert Screw Socket
4 . Align the 6 holes to the mounting plate with the drilled holes .
5 . Route the cable through the cable hole of the mounting plate, and connect
to corresponding external devices’ cables .
6 . Align the device with the mounting plate and hang the device on the
mounting plate .