ATN TITEW1000 Thermal Entry Wizard Access Control Station with Table Stand Mount - Manual (Page 22)

42 43
6.8. SYSTEM SETTINGS
On the System Settings page, you can set the system basic parameters, the
face parameters, and upgrade the firmware .
6.8.1. Set Basic Parameters
You can set the community No ., building No ., the unit No ., voice prompt,
voice volume, application mode, and white light brightness .
On the Home page, tap System (System Settings) to enter the System Set-
tings page .
Figure 6-10. Basic Parameters
Table 6-2. Basic Parameters
Parameter Description
Community No . Set the device installed community No .
Building No . Set the device installed building No .
Unit No . Set the device installed Unit No .
Voice Prompt Tap or to disable or enable the voice prompt .
Voice Volume
Adjust the voice volume . The larger the value, the louder the
volume .
Application Mode
You can select either others or indoor according to actual
environment .
White Light
Brightness
Set the supplement white light's brightness . The brightness
ranges from 0 to 100 .
0 refers to turning off the light . 1 refers to the darkest, and
100 refers to the brightest
6.8.2. Set Face Picture Parameters
You can set the face 1:N (security) level, 1:1 (security) level, recognition in-
terval, liveness security level, WDR level, pupillary distance, face with mask
detection and ECO mode .
On the Home page, tap System (System Settings) to enter the System Set-
tings page .
Figure 6-11. Face Picture Parameters