ATN TITEW1000 Thermal Entry Wizard Access Control Station with Table Stand Mount - Manual (Page 20)

38 39
6.4.5. Set Authentication Mode
After adding the user’s face picture, password, or other credentials, you
should set the authentication mode and the user can authenticate his/her
identity via the configured authentication mode .
Steps
1 . Long tap on the initial page and log in the backend .
2 . Tap User
→ Add User/Edit User → Authentication Mode .
3 . Select Device or Custom as the authentication mode .
Device
If you want to select device mode, you should set the terminal authentica-
tion mode in Access Control Settings page first . For details see Setting Access
Control Parameters .
Custom
You can combine different authentication modes together according to your
actual needs .
4 . Tap to save the settings .
6.4.6. Search and Edit User
After adding the user, you can search the user and edit it .
Search User
On the User Management page, Tap the search area to enter the Search
User page . Tap Card on the left of the page and select a search type from the
drop-down list . Enter the employee ID, card No ., or the user name for search .
Tap
to search .
Edit User
On the User Management page, select a user from the user list to enter the
Edit User page . Follow the steps in User Management to edit the user param-
eters . Tap
to save the settings .
NOTE
The employee ID cannot be edited.
6.5. TEMPERATURE MEASUREMENT SETTINGS
You can set the temperature measurement parameters, including tempera-
ture detection, over-temperature alarm threshold, door not open when tem-
perature is abnormal, temperature measurement mode, measurement area
calibration, measure area, etc .
On the Home page, tap Temp (Temperature) to enter the Temperature Set-
tings page . Edit the temperature measurement parameters on this page and
tap
to save the settings .
Figure 6-9. Temperature Measurement Parameters C/F
The available parameters descriptions are as follows:
Table 6-1. Temperature Measurement Parameters Descriptions
Parameter Description
Enable Temperature
Detection
When enabling the function, the device will authenticate
the permissions and at the same time take the temperature .
When disabling the device, the device will authenticate
the permissions only .
Over-Temperature
Alarm Threshold
(Max ./Min .)
Edit the threshold according to actual situation . If the
detected temperature is higher or lower than the configured
parameters, an alarm will be triggered . By default, the value
is 99 .14°F .
Door Not Open
When Temperature
is Abnormal
When Enabling the function, the door will not open
when the detected temperature is higher or lower than
the configured temperature threshold . By default, the
temperature is enabled .
Temperature
Measurement Only
When enabling the function, the device will not authenticate
the permissions, but only take the temperature . When
disabling the function, the device will authenticate the
permissions and at the same time take the temperature .
If read temp only is enabled, the door mechanism will un-
lock if wired correctly to the wiegand cord and a good read-
ing is obtained .
Measurement Area
Calibration/Measure
Area Settings
Configure the temperature measurement area and the
correction parameters .