ATN TITEW1000 Thermal Entry Wizard Access Control Station with Table Stand Mount User Manual

Page 33

5 . Select Local as the card issuing mode .

Figure 7-2. Issue a Card by Local Mode

6 . Set other related parameters .

Card Enrollment Station

Select the model of the connected card enrollment station .

NOTE

Currently, the supported card enrollment station models include

DS-K1F100-D8, DS-K1F100-M, DS-K1F100-D8E, and DS-K1F180-D8E.

Card Type

This field is only available when the model is DS-K1F100-D8E or DS-

K1F180-D8E . Select the card type as EM card or Mifare card according to the

actual card type .

Buzzing

Enable or disable the buzzing when the card number is read successfully .

Card No. Type

Select the type of the card number according to actual needs .

M1 Card Encryption

This field is only available when the model is DS-K1F100-D8, DS-K1F100-

D8E, or DS-K1F180-D8E . If the card is M1 card, then you can enable the M1

Card Encryption function and select the sector of the card to encrypt .

7 . Click OK to confirm the operation .
8 . Place the card on the card enrollment station and click Read to get the

card number . The card number will display in the Card No . field automat-

ically .

9 . Click Add .
The card will be issued to the person .

7.4.4. Upload a Face Photo from Local PC

When adding person, you can upload a face photo stored in local PC to the

client as the person's profile .

Steps

1 . Enter Person module .
2 . Select an organization in the organization list to add the person and click

Add .

NOTE

Enter the person's basic information first. For details about configuring

person's basic information, refer to Configure Basic Information.

3 . Click Add Face in the Basic Information panel .
4 . Select Upload .
5 . Select a picture from the PC running the client .

NOTE

The picture should be in JPG or JPEG format and smaller than 200 KB.

6 . Optional: Enable Verify by Device to check whether the facial recognition

device managed in the client can recognize the face in the photo .

7 . Confirm to add the person .
• Click Add to add the person and close the Add Person window .
• Click Add and New to add the person and continue to add other persons .

7.4.5. Take a Photo via Client

When adding a person, you can take a photo of the her/him via the client and

set this photo as the person's profile .

Before You Start

Make sure PC running the client has a camera or you have connected other

USB camera to the PC .

Steps

1 . Enter Person module .
2 . Select an organization in the organization list to add the person and click

Add to enter Add Person window .

NOTE

Enter the person's basic information first. For details, refer to Config-

ure Basic Information.

3 . Click Add Face in the Basic Information area .
4 . Select Take Photo to enter Take Photo window .
5 . Optional: Enable Verify by Device to check whether the captured face

photo can meet the uploading requirements .

6 . Take a photo .

a) Face to the camera and make sure your face is in the middle of the col-

lecting window .

b) Click

to capture a face photo .

c) Optional: Click

to capture again .

d) Click OK to save the captured photo .