ATN TITEW1000 Thermal Entry Wizard Access Control Station with Table Stand Mount - Manual (Page 7)

12 13
Table 2-1. Description of Face Recognition Terminal
No. Name
1 USB Interface
2 Card Swiping Area
3 Touch Screen
4 Camera
5 IR Light
6 White Light
7 Thermographic Module
8 IR Light
9 Camera
10 TAMPER
11 Thermographic Module Interface
12 Debugging Port
13 Power Interface
14 Wiring Terminals
15 PSAM Card Slot (Reserved)
16 Network Interface
C H AP T E R 3 . I N S TA LL AT I O N
3.1. INSTALLATION ENVIRONMENT
• Avoid backlight, direct sunlight, and indirect sunlight .
• For better recognition, there should be light source in or near the installa-
tion environment .
• Indoor and windless environment use only .
NOTE
For details about installation environment, see Tips for Installation
Environment.
3.2. FLUSH MOUNTING
Steps
1 . Install a gang box .
2 . Connect the thermographic module and the main body .
Figure 3-1. Connect Thermographic Module
3 . Use 5 supplied screws (4_KA4 × 22-SUS) to secure the mounting plate on
the gang box .
4 . Route the cable through the cable hole of the mounting plate and connect
to corresponding external devices’ cables .
5 . Align the device with the mounting plate and hang the device on the
mounting plate . Make sure the two sheets on each side of the mounting
plate have been in the slots at the back of the device .
Figure 3-2. Install Device