Pilz PSS SB HYD, Basic license - Manual (Page 175)

Modular Block System: Hydraulic Presses 6-113
Yes
x
x
x
x
x
No
x
o
o
x
/
Yes
x
x
x
x
-
No
x
o
o
x
-
Yes No Reset lock ( ARSt )
Function test required ( NoFT )
Request ( RQST )
Open gate
Close gate
Request ( RQST )
Reset ( RSET )
Reset lock (input parameter ARSt)
If the reset lock is active ( ARSt = 0), you will need to reset after each
• Opening and subsequent closing/locking of the gate (not applicable if the
gate was not opened between unlocking and locking)
• Function test
• Error
Only then can the enable be given. If no other errors are present, the
enable will be set.
If the reset lock is not active ( ARSt = 1), the enable will be set directly,
without a reset, after the above situations.
Note: This procedure is independent of the status of the input parameter
AuSt
Key:
x:
Action must be performed
o: Action can be performed
/ : Action does not need to be performed if the gate was not open