Pilz PSS SB HYD, Basic license - Manual (Page 112)

6-50 Modular Block System: Hydraulic Presses
Standard Function Blocks SB066
Required reaction from operator in the case of a fault
Parameter ARST 0 1 0 0 1 1
AuST 0 0 0 1 *1 0 1 *1
NFkT 0 0 1 1 1 1
Function Status of gate open shut open shut open shut open shut open shut open shut
test Close gate x - x - x - x - x - x -
Open and
x *4 x x *4 x x *4 x x *4 x x *4 x x *4 x
close gate
Strt
- - -
Table 3: Reaction in the case of a fault
x Function activated or
operator reaction required
- Function not activated or
no operator reaction required or
reset not required
Reset required via the reset input
*1 The function “No start-up disabler on PSS cold/warm start” is only
possible when no function test is set (
NFkT = 1).
*2 First close the gate, then open it and close it again.
*3 The enable can be set by opening/closing the gate or by a pulse at the
reset input.
*4 When synchronisation time S1-S2 is exceeded (error bit 09)