Yamaha HTR-5950 - Manual (Page 93)

■ Speaker Impedance SF IrlP.
Use this feature to set the speaker impedance of this unit
so that it matches that of your speakers.
Choices: 8QMIN, 6QMIN
• Select "8QMIN” to set the speaker impedance to 8 Q .
• Select ‘'6QMIN” to set the speaker impedance to 6 Q .
SP IMP.
saMiN
6QMIN
Speaker Impedance level
Fronl
If you use one sel (A or B).
the impedance of each
speaker mu sr be 8 Q or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 16 or
hicher.''
Center
Surround
The impedanee of eaeh
speaker mu st be 8 Q or
hieher.
Surround baek
Front
If you use one set (A or B).
the impedance of each
speaker must be 4 Q or
higher.
If you use two sets (A and
B). the impedance of each
speaker mu st be 8 Q or
higher.
Center
Surround
The impedance of each
speaker mu st be 6 Q or
higher.
Surround back
The Canada model cannot use two separate speaker systems
(A and B) simultaneously when ''SP IMP/' is set to "8QM1N“
■ Factory presets i i : .i !
Use this feature to reset all the parameters of this unit to
the initial factory settings (see page 97).
Choices:
CANCEL RESET
• Select “CANCEL” not to reset any parameters of this
unit.
• Select “RESET” to reset the parameters of this unit.
N o t e s
• This setting completely resets all the parameters of this unit
including the "SET MENU" parameters. However, the
advanced setup menu parameters will not be initialized.
' The initial factory settings are activated next lime you turn on
this unit.
ADVANCED SETUP
■ Remote control AMP ID ir:l:Eii01"l:E flilF-'
U.se this feature to set the AMP ID of this unit for remote
control recognition {see page 93).
Choices:
ID1, ID2
• Select “IDI” when the remote control AMP ID library
code is set to “00001”.
• Select “ID2” when the remote control AMP ID library
code is set to “00002”.
Note
You need to set the corresponding remote control AMP library
code for the remote control (see page 93).
■ Remote control TUNER ID FiEI liEiE:: Ti.ir l
Use this feature to set the TUNER ID of this unit for
remote control recognition (see page 93).
Choices: ID1, ID2
• Select “IDI” when the remote control TUNER ID
library code is set to “81916”.
• Select “ID2” when the remote control TUNER ID
library code is set to “81917”.
Note
You need to set the corresponding remote control TUNER library
code for the remote control (see page 93).
■ Remote control XM ID iuEiliEiT'sE i-lil
(U.S.A. model only)
Use this feature to set the XM ID of this unit for remote
control recognition (see page 94).
Choices:
ID1, ID2
• Select “IDI” when the remote control XM ID library
code is set to “819 IS”.
• Select “ID2” when the remote control XM ID library
code is set to “81919”.
Note
You need to set the corresponding remote control XM library
code for the remote control (see page 93).
89