Setting the speaker impedance – Yamaha HTR-5950 User Manual

Page 30

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CONNECTIONS

Setting the speaker impedance

CAUTION

If you are to use 4 or 6 ohm speakers, set “SP
IMP.” to “6QWIIN” as follows BEFORE using this
unit.

Press STRAIGHT (EFFECT) on the front
panel repeatedly to select “6nMIN”.

The following display appears in the front panel
display.

Make sure this unit is set to the standby
mode.

See page 27 for details about turning on this unit or
setting it to the standby mode.

Press and hoid STRAiGHT (EFFECT) on the

front panei and then press STANDBY/ON to
turn on this unit.

This unit turns on, and the advanced setup menu

appears in the front panel display.

While holding

down

"fay n

5 Press STANDBY/ON on the front panel to

save the new setting and set this unit to the
standby mode.

Note

The setting you made is relfected next time you turn on this

Press PROGRAM <] / !> on the front panel
repeatedly to select “SP IMP.”.

The following display appears in the front panel

display.

PROGRAM I -