Yamaha HTR-5950 - Manual (Page 19)

CONNECTIONS
■ Connecting the speaker cable
1 Remove approximately 10 mm (0.4 in) of
insulation from the end of each speaker
cable and then twist the exposed wires of the
cable together to prevent short circuits.
10 mm (0.4 in)
i
■ Connecting the banana plug
The banana plug is a single-poie electricai connector
widely used to terminate speaker cables.
Banana plug
1 Tighten the knob.
2 Loosen the knob.
Red: positive {+)
Black: negative (-
2 Insert the banana plug connector into the
end of the corresponding terminal.
3 Insert one bare wire into the hole on the side
of each terminal.
Red: positive (+)
Black: negative (-)
4 Tighten the knob to secure the wire.
Red: positive (+)
Black: negative (-}
15