Enjoying multi-channel sources in 2-channei stereo, Enjoying pure hi-fi stereo sound, Enjoying unprocessed input sources – Yamaha HTR-5950 User Manual

Page 42

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

USING AUDIO FEATURES

Enjoying multi-channel sources in

2-channei stereo

You can mix down multi-channel sources to 2 channels
and en joy playback in 2-channel stereo.

Set the component selector switch to AMP and

then press STEREO on the remote control

repeatedly to select “2ch Stereo”.

AMP

S0URC£

o
a

STEREO

Enjoying pure hi-fi stereo sound

The “DIRECT STEREO” mode allows sources to bypass
the decoders and DSP processors of this unit so that you
can enjoy pure hi-fi sound from 2-channel PCM and

analog sources.

Set the component selector switch to AMP and

then press DIRECT ST. on the remote control to

select “DIRECT STEREO”.

AMP

;;;::ì:::.rм

мммм

pìtt

!!.,;

Dih±£i

;

'E!:

fì

• You can use a subwonter with this program when ’'LFE/BASS

OUT" is set to "SWFR" or "BOTH'" (see page 79).

• You can also select the ■'2ch Stereo" mode by pressing

PROGRAM ^ on the front panel repeatedly.

Enjoying unprocessed input

sources

When this unit is in the “STRAIGHT” mode, 2-channel

stereo sources are output from only the front left and right
speakers. Multi-channel sources are decoded straight into

the appropriate channels without any additional effect
processing.

Set the component selector switch to AMP
and then press STRAIGHT on the remote
control to select “STRAIGHT”.

Notes

• To avoid unexpected noise, do not play CDs encoded in DT.S

when the “DIRECT STEREO” mode is selected.

• When multi-channel signals (Dolby Digital and DTS) are input,

this unit automatically switches to the corresponding analog
input. When “t)TS” is selected as the input mode (see page 34),
no sound will be output.

• No sound will be output from the subwoofer.
• “TONE CONTROL” (sec page 32) and “SOUND MENU” (sec

page 78) settings (except for speaker level settings) are not
effective.

• The front panel display automatically dims.

si's

You can also select the “DIRECT STEREO” mode by pressing
PROGRAM <1 /1> on the front panel repeatedly.

AMP

I t II I I I *

I I'l* (•••I I 1 “I

To deactivate the “STRAIGHT” mode, press
STRAIGHT on the remote control again so

that “STRAIGHT” disappears from the front

panel display.

The sound effect is turned back on.

You can also select the "STRAIGHT” mode by pressing
STRAIGHT (EFFECT) on the front panel.