0 infrared window, Code set, 0 input selector buttons – Yamaha HTR-5950 User Manual

Page 10: 0 sound field program selector buttons, 0 speakers, 0 enhancer, 0 level, Sound field program descriptions, Remote control

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CONTROLS AND FUNCTIONS

Remote control

This section describes the function of each control on the remote control used to control this unit. To operate other

components, see "REMOTE CONTROL FEATURES” on page 90.

Notes

•

The XM Satellite Radio conlrolliiig functions in the following buttons (XM, XM MEMORY, SRCH MODE, DISPLAY, cursor

buttons /\ / sy / < / X niiineric buttons anti ENT) arc only applicable to the U.S.A. model and are operational only when ”XM" is
selected as the input source. For details, see *'XM Satellite Radio controls and functions" on page

53.

•

The operation mode of the remote control buttons in the shaded area below depends on the component selector switch position. Set the

component selector switch to AMP to control this unit. To control the TUNER functions, set the component selector switch to
SOURCE and then press TUNER to select ‘TUNER” as the iitput source,

■ Controlling this unit

”S1jr

Set the component selector switch to AMP to control this

unit.

Infrared window

Outputs infrared control signals. Aim this window at the

component you want to operate (see page 8).

@ CODE SET

Use to set up remote control codes (see page 92).

Input selector buttons

Select the input source you want to control.

Note

The corresponding input selector button for the currently selected

input source lights up for approximately 5 seconds after you press
any buttons on the remote control, showing which source

component is currently being operated.

Sound field program selector buttons

Select sound field programs (see page 63).

- Use SELECT to play back 2-channel sources in

surround (.see page 42).

- Use EXTD SUR. to switch between 5.1 and

6.1-channel playback of multi-channel sources
(see page 41).

- Use DIRECT ST. to play back 2-channel sources in

hi-fi stereo sound (see page 38).

SPEAKERS

Turns on or off the set of front speakers connected to the

FRONT A and/or B terminals on the rear panel. Press this
button repeatedly to toggle as follows:

r->

A on

B on

A and B off

ENHANCER

Turns on or off the Compressed Music Enhancer mode

(see page 36).

LEVEL

Selects the speaker channel to be adjusted and sets the

output level (see page 35).