Yamaha HTR-5950 User Manual

Page 103

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TROUBLESHOOTING

Problem

Cause

Remedy

Soo

pngo

The sound suddenly

goes off.

TIk'

pii

'lt\ l

h ?ll

vllVIlill

y h;i> h;:'.;‘n ;

.lk-\l

because of a short circuit, etc.

(lu'ck that the ■■peakci impcdaiKk'

U iiig, o ci'i red

2(\

S’.i

Check Ihiit the speaker wires are not touching each
other and then turn this unit hack on.

—

The sleep timer has set this iiiiit to the

standby mode.

Turn on this unit, and play the source again.

—

The sound is muted.

Press MUTE or VOLUME +/- on the remote control
to resume audio output.

Sound is heard from

the speaker on one

side only.

Incorrect cable connections.

Connect the cables properly. If the problem persists,
the cables may be defective.

Incorrect settings in “SPEAKER
LEVEL". "

Adjust the "SPEAKER LEVEL” settings.

Only the center

speaker outputs

substantial sound.

When playing a monaural source with a

CINEMA DSP program, the source signal

is directed to the center channel, and the
front and surround speakers output effect
sounds.

No sound is heard

from the center

speaker.

“CENTER .SP” in “SET MENU” is set to
“NONE”.

Set “CENTER SP” lo “SML” or “ERG”.

One of the HiFi DSP programs (except for

"6ch Stereo”) has been selected.

Try another sound field program.

No sound is heard

from the surround

speakers.

“SUR. L/R SP" in “SET MENU" is set to
“NONE”.

Set “SUR. L/R SP” lo “SML" or “ERG”.

This unit is in the “STRAlCfHT” mode

and a monaural source is being played

back.

Press STRAIGHT (EFFECT) on the front panel so
that "STRAIGHT” disappears from the front panel
display.

No sound is heard

from the surround

back speaker.

“SUR. L/R SP” in “SET MENU” is set to
“NONE” and “SUR. B SP” is
atilomiitieally set to "NONE”.

Set “SUR. L/R SP” and "SUR. B SP” to “SML” or
“LRG”.

“SUR. B SP” in “SET MENU” is set to
“NONE”.

Set “SUR. B SP” to “SML” or “LRG”.

No sound is heard

from the subwoofer.

■^LFE/BASS OUT” in ^'SET MENU” is
set to "FRNT” when a Dolby Digital or
DTS signal is being played.

Set “LFE/BASS OUT” to “SWFR” or “BOTH”.

“LFE/BASS OUT” in “SET MENU” is
set to “SWFR” or “FRNT” when a 2-

chaniicl source is being played.

Set “LFE/BASS OUT” to “BOTH”.

The source does not contain low-

frequency signals.

--------- ----------------------- -----------^