Yamaha HTR-5950 - Manual (Page 35)

PLAYBACK
CAUTION
Extreme caution should be exercised when you play back CDs encoded in DTS. If you play back a CD
encoded in DTS on a DTS-incompatible CD player, you will only hear some unwanted noise that may
damage your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the
sound output level of your CD player before you play back a CD encoded in DTS.
(U.S.A. model)
;,.p»
TZ
3J-7
law#
1 Turn on the video monitor connected to this
unit.
2 Press SPEAKERS A or B on the front panel
(or set the component selector switch to
AMP and then press SPEAKERS on the
remote controi repeatedly).
Each time you press SPEAKERS A or B, the
respective speakers are turned on or off.
SPEAKERS
A B
Front panel
or
Ô
SPEAKERS
%
Rotate the INPUT selector on the front panel
(or press one of the input selector buttons on
the remote control) to select the desired
input source.
■■ ci'j • •{ Cl
•: ./'■ ■:••• =
■ ■ V
V-AU»; • Í I.-­
....../ ..
Front panel Roniot" contini
The name of the currently selected input source
appears in the front panel display and in the OSD for
a few seconds.
Available input sources
DVR »-AUX
DUD HUTU
CD XM
Currently selected
input source
Currently selected
input mode
Notes
• If you are to select an input source connected via digital
connections, set "INPUT MODE” to “AUTO" or "DTS"
(see page 34).
• For details about controlling XM Satellile Radio when
"XM" is selected as the inpul source, see ptige .3.3.
4 start playback on the selected source
component or select a broadcast station.
Refer to the operating instructions for the source
component.
See page 45 for details about tuning instructions.
Remote control
31