HP 9600 Series User Manual
Page 105
7-2
ENWW
Power light blinks twice, stays off,
then repeats the pattern.
Printer is cancelling a print job.
No action required.
Power light on,
Resume light blinks.
Check for one of the following conditions:
Printer is waiting for special media to dry.
Press the Resume button if you do not want to wait.
You can change the dry time in the printer driver (see
for instructions).
Printer is out of paper.
Load paper and press the Resume button to continue
the print job.
Printer is waiting for a manual feed load.
If using front or rear manual feed slot, load paper and
press the Resume button to continue the print job.
There is a media size mismatch.
Make sure the paper size selected in the printer driver
matches the paper size loaded in the printer.
The printer has printed a banner and the banner needs
to be removed from the printer.
Press the Resume button to eject the banner media.
I/O stall.
Make sure your system is running properly and the
printer is properly connected to your system. Then
resend the print job. To check the system, see the
guidelines in
.
Power light off, Resume light blinks.
Paper jam or paper motor stall.
). After
clearing the jam, press the Resume button to continue
the print job.
If no paper jam exists, press the Resume button. If this
does not work, turn off the printer, and then turn it on
again. Then resend the print job.
Power and Resume lights
blink together at same time.
Carriage stall.
If there is a paper jam, clear the jammed paper (see
). After clearing the jam, press the
Resume button to continue the print job.
If no paper jam exists, press the Resume button. If this
does not work, turn off the printer, and then turn it on
again. Then resend the print job.
Power and Resume lights
blink alternately.
Service station stall.
If there is a paper jam, clear the jammed paper (see
). After clearing the jam, press the
Resume button to continue the print job.
If no paper jam exists, press the Resume button. If this
does not work, turn off the printer, and then turn it on
again. Then resend the print job.
x2
x2