HP INTEGRITY RX3600 - Manual (Page 326)

2 S Serial Acpi(HWP0002,0)/Pci(1 1)
3 P VGA Acpi(HWP0002,0)/Pci(4 0)
Example D-11 conconfig 2 primary command
To change primary operating system console
Shell> conconfig 2 primary
CONSOLE CONFIGURATION
Index Status Type Device Path
----- ------ ---- -----------
1 NC Serial Acpi(PNP0501,0)
2 P Serial Acpi(HWP0002,0)/Pci(1 1)
3 S VGA Acpi(HWP0002,0)/Pci(4 0)
Example D-12 conconfig 3 off command
To disable a console
Shell> conconfig 3 off
CONSOLE CONFIGURATION
Index Status Type Device Path
----- ------ ---- -----------
1 NC Serial Acpi(PNP0501,0)
2 P Serial Acpi(HWP0002,0)/Pci(1 1
3 NC VGA Acpi(HWP0002,0)/Pci(4 0)
Example D-13 conconfig 3 on command
To enable a console
Shell> conconfig 3 on
CONSOLE CONFIGURATION
Index Status Type Device Path
----- ------ ---- -----------
1 NC Serial Acpi(PNP0501,0)
2 P Serial Acpi(HWP0002,0)/Pci(1 1)
3 S VGA Acpi(HWP0002,0)/Pci(4 0)
ioconfig
Use this command to deconfigure or reconfigure I/O components or settings.
Syntax
ioconfig
Parameters
specifies device connection policy setting
specifies PCIe MPS optimization setting
specifies system wake-on-lan setting
specifies to configure or deconfigure a feature or component
Operation
The ioconfig file is used to retain information on system's I/O configuration across reboots.
The ioconfig file is created by insf at install time; and is modified by insf, rmsf, and ioscan
when devices are added or removed. The only purpose of the ioconfig file to maintain
configuration information when the system is not running.
326 Utilities