HP STORAGEWORKS E1200-160 - Manual (Page 92)

Serial/Telnet User Interface
92 Network Storage Router e1200-160
Telnet UI Access
To open a Telnet session, the IP address of the router and a Telnet client utility are
required.
Note: After each reboot, a new Telnet session must be started. If the router is reset to
factory settings, the Ethernet port will have to be re-configured using the serial
interface.
From most Windows 9x, Windows NT, and Windows 2000 systems, a Telnet
session can be started from the Command (DOS) shell using the following steps:
1. From the Windows Start Menu, open the Command Prompt (DOS) window.
2. At the ‘>’ prompt, enter:
> TELNET <IP ADDRESS>
where < IP ADDRESS > is the IP address of the router
3. Enter the user name and password.
The default user name is root and the default password is password .
HP recommends that the user name and password be changed from the default
values. The Configuration Menu is displayed.
Serial UI Access
To open a serial session, a terminal emulator utility is required.
From most Windows 9x, Windows NT, and Windows 2000 systems, a
HyperTerminal session can be started using the following steps:
1. From the Windows Start Menu, open HyperTerminal.
2. Name the new terminal session.
3. Indicate the appropriate COM port.