HP STORAGEWORKS E1200-160 - Manual (Page 167)

167 Network Storage Router e1200-160
B
Controller LUN Commands
BF
The HP StorageWorks Network Storage Router supports and executes the set of
SCSI-3 commands listed in this Appendix. These commands can be received as
FCP commands over the Fibre Channel bus and are supported by the Controller
LUNs. This document refers to these commands as Controller LUN commands.
Complete definitions of SCSI-3 commands can be found in the SCSI-3 standard
available from the American National Standards Institute (ANSI).
This Appendix explains general Controller LUN commands.
To first determine which router LUNs are controller LUNs and which are device
LUNs, the host software must use the Inquiry general command.
Controller LUNs are addressable in all addressing modes. In SCC mode, there is
one controller LUN. In Auto-Assigned and Indexed modes, there can be up to four
configurable controller LUNs.
Note: Controller LUNs are numbered in sequence following the last device LUN,
without any gaps. A controller LUN may be placed anywhere in custom tables.