HP STORAGEWORKS E1200-160 - Manual (Page 100)

Serial/Telnet User Interface
100 Network Storage Router e1200-160
■ 7) Toggle DHCP Configuration enables or disables support for Dynamic
Configuration Protocol.
When DHCP is enabled, the router will request a dynamic IP address from the
DHCP server on the Ethernet network.
Some DHCP servers allow a lease reservation to be set up for an IP address by
providing the server with the Ethernet MAC address. The DHCP server will
then always provide the same IP address to the router. This setup can be
useful for remote management of the router such as Telnet or Visual Manager
Because the method of setting up a lease reservation varies depending on the
DHCP server being used, contact your Network Administrator for assistance.
Note: To use the DHCP feature, a DHCP server must be operational on the Ethernet
network. If the DHCP feature is used when there is no DHCP server, DHCP standards
require the router wait three minutes for a response from a DHCP server before timing
out.
■ 8) Change SNMP Settings is not supported.
■ 9) Change Security Settings changes security settings, including the user
name and password.
The default user name is root and the default password is password .
Caution: To ensure security, change the user name and password from the
default settings.
Note: The security settings entered here affect all user interfaces.
User names and passwords should be unique and kept confidential. HP
recommends using a combination of letters and numbers when creating user
names and passwords.