HP STORAGEWORKS E1200-160 - Manual (Page 146)

FTP User Interface
146 Network Storage Router e1200-160
Access the FTP User Interface (UI)
To access the router using an FTP UI:
1. Connect the router to the Ethernet network used by the host computer.
2. Start an FTP session using the router IP address:
ftp <IP address>
where IP address is the IP address of the router.
The default router IP address is 1.1.1.1 .
Note: You may also need to specify the external directory location where your FTP
utility will store the backup configuration file.
3. Enter the user name and password.
The default user name is root and the default password is password .
Backup and Restore Configuration Settings
The router supports the backup and restore of configuration settings over FTP.
This allows multiple configuration files to be maintained in a location external to
the router. When backing up a configuration, the settings are saved from the flash
memory on the router to a binary file in an external location determined by the
user.