Configuration overview, 2 configuration overview – HP STORAGEWORKS E1200-160 User Manual
Page 25
25
Network Storage Router e1200-160
2
Configuration Overview
2F
The HP StorageWorks Network Storage Router can be configured and managed
using several user interfaces (UI). Each UI is introduced in this chapter, along
with information about common configuration settings. Included are:
■
Router Default Ethernet Settings
■
■
— Controller LUN Commands
— SCSI Bus Configuration
— Default Fibre Channel Port Configuration
— Fibre Channel Switched Fabric Configuration
— Discovery Mode
— Host Device Configuration
— Logical Unit Management
— Buffered Tape Writes
Note:
Before attempting to configure the router, a basic understanding of Fibre Channel and
SCSI devices is recommended. For information on SCSI standards, refer to publications from the
X3T10 committee of ANSI (American National Standards Institute). For information on Fibre
Channel standards, refer to publications from the X3T11 committee of ANSI. For those who are
interested in purchasing approved American National Standards and Technical Reports, contact
ANSI at (212) 642-4900.