Dahua Technology DH-IPC-EBW81242N-AS-S2 12MP Outdoor Network Panoramic Fisheye Camera with Night Vision - Manual (Page 88)

Operation Manual
77
6.6.3 Peripheral Management
6.6.3.1 Configuring Serial Port
Set the serial port of the external device.
Step 1
Select > System > Peripheral > Serial Port .
Step 2 Configure parameters.
Figure 6-75 Serial port settings
Table 6-29 Description of serial port settings parameters
Parameter Description
IP Address
Enter the corresponding device address. It is 1 by default.
Make sure that the address is the same as the device address; otherwise you
cannot control the device.
Baud Rate Configure device baud rate. It is 9600 by default.
Data Bits It is 8 by default.
Stop Bits It is 1 by default.
Test It is none by default.
Step 3 Click Apply .
6.6.3.2 Configuring External Light
You need to configure external light mode when the external light is used.
Prerequisites
● Connect external light with RS-485 port.
● You have configured serial port parameters. For details, see "6.6.3.1 Configuring Serial Port".