Dahua Technology DH-IPC-EBW81242N-AS-S2 12MP Outdoor Network Panoramic Fisheye Camera with Night Vision - Manual (Page 141)

Operation Manual
130
Step 2 Click next to Video Metadata , and then click Next .
Step 3 Click the Rule Config tab.
Step 4 Click Add Rule to select rules.
The added rules will be display in the list. Click the text box under Name to edit the rule
name. The rule is enabled by default.
Figure 8-31 Rule configure (video metadata)
Step 5 Configure Picture .
1) Click .
2) Set overlay of motor vehicle, non-motor vehicle and people and the box position.
This section takes the configuration of non-motor vehicle overlay as an example.
Figure 8-32 Picture (non-motor vehicle)
3) Click Apply .
Step 6 (Optional) Click the icons at the right side of the image to filter targets in the image.
● Click to draw rule line in the image.
When targets pass the tripwire along the configured direction line, they will be
counted.
● After the rule is enabled, the detection area is displayed. Click , and you drag the
any corner of the box to adjust the size of the area, and press the left mouse button and
move the box to adjust the position.
● Click to draw an area exclusion area for face detection in the image, and right-click
to finish the drawing..
● Click to draw the minimum size of the target, and click to draw the maximum
size of the target. Only when the target size is between the maximum size and the
minimum size, can the alarm be triggered.
● Click , and then press and hold the left mouse button to draw a rectangle, the pixel