Datavideo SE-1200MU 6-Input Switcher and RMC-260 Controller Bundle - Manual (Page 34)

34
Chapter 6 PC Control Panel
This chapter provides users with general descriptions of various functions that are available with the SE-
1200 MU controller software. Before you begin, see
Chapter 3 for software installation.
6.1 Sources Panel
Windows PC Users
This panel on the SE-1200 MU control software consists of three identical rows of buttons and is used to
assign sources or select images for Program or Preset outputs. The buttons are labelled from left to right as
Black , sources 1 to 6 , and Bkg (Matte) .
MAC Users
This panel on the SE-1200 MU control software consists of three identical rows of buttons and is used to
assign sources or select images for Program or Preset outputs. The buttons are labelled from left to right as
Black , sources 1 to 6 , and Matte .
Note: See Section 7.4 Bus Matte Setup for configuring the Bkg/Matte button.
6.1.1 AUX BUS
This row of buttons is typically used to assign sources for the setup of the PIP, Linear, Chroma and Luma
Keyer functions. If a keyer or PIP function is active/ON then the selected AUX button will be backlit red.
6.1.2 PROGRAM
This row of buttons is typically used to select sources or images for the SE-1200 MU main Program output.
The currently selected source being sent to the Program output will be
backlit Red . Simple cuts between
sources can be performed on this row by clicking on the source number required for the next shot.
6.1.3 PRESET
This row of buttons is typically used to select sources or images for the SE-1200 MU Preview output. The
currently selected source will be
backlit Green . The selected button on the Preset row will change from
Green to Yellow during Preview-Program transitioning using T-Bar.