Datavideo SE-1200MU 6-Input Switcher and RMC-260 Controller Bundle - Manual (Page 24)

24
Chapter 4 Basic Video Setup
In this chapter, you will learn the basics of video setup.
4.1 SE-1200 MU Multi View Output
The Multi view shows monitoring images for Preview (PVW), Program (PGM), Inputs 1~6 , as well as SDI
outputs 1 and 2.
The SE-1200 MU multi view output can be supplied locally, from either the HDMI1 or SDI outputs 1 and 2
on the unit’s rear panel, see
section 2.2 (Chapter 2). The multi view can also be streamed over a
LAN/internet connection, see section 3.2.2 (Chapter 3).
The default multi view output, when new, is from HDMI output 1. This HDMI output operates at 1080P,
720P or 1080i depending on the video standard chosen, see
section 4.3 (Chapter 4).
The SE-1200 MU can also show audio level bars overlaid on the Program image within the multi view. This
confirms if analogue XLR audio input is being received and embedded to the selected Program output(s).
A Red tally indication box is shown around the selected Program source(s). This video image is also seen at
the switcher’s selected Program output(s). A Green tally indication box is shown around the selected
Preview source. This will be the image source to be mixed to, wiped in, or cut to next depending on the
user’s preference.
Images SDI out 1 and SDI out 2 confirm what is being sent from those SDI outputs. These outputs can be
configured differently by the user, see section 5.2.1 (Chapter 5).