Roland TD-50X Prismatic V-Drums Sound Module - Manual (Page 64)

64
Appendix
Message Meaning Action
USB Offline!
The USB cable was disconnected (or USB communication
was interrupted for some reason).
If you see this message but can’t figure out why, check the
USB cable to make sure it is connected properly, and that
there isn’t a short in the cable.
Change Audio Routing to
LOOPBACK!
The audio routing has switched to loopback mode.
When using the loopback setting, the USB audio input and
output may connect directly and inadvertently produce
a very loud sound, depending on the settings of your
computer and the TD-50X. For this reason, use caution with
this setting.
Change Audio Routing to
NORMAL!
The audio routing has switched to normal mode. –
User Sample Unsupported
format!
TD-50X can import the file
formatted 44.1kHz, 16or24bit
.wav file.
This unit does not support this user sample format. Save the sample in a format that this unit can recognize.
Incorrect License!
Remove License.
The license data for the data you are loading does not
match the license data currently stored in this unit.
Check whether the data you are loading is correct. Also, you
can use the “Remove License” function to delete the license
data already stored on this unit (p. 62).
You cannot load different license data if license data is
already saved in this unit.
Other Messages
Message Meaning Action
USB Driver
The modified settings will
become effective after
reconnect the USB cable.
The USB driver settings take effect when you unplug and
reconnect the USB cable.
Unplug the USB cable and reconnect it.
XStick always effective Cross-stick technique is always enabled. –
XStick switch available The cross-stick switch is enabled.
In the DRUM KIT screen, press the [F4] (XSTICK) button to
switch between sounding or not sounding the cross-stick
sound (p. 17).