Roland TD-50X Prismatic V-Drums Sound Module - Manual (Page 23)

23
Performing
QUIET COUNT settings
In the QUIET COUNT screen, press the [F2] (SETUP) button to access
the settings screen.
Parameter Value Explanation
Measures
2, 4, 8, 16
(measures)
Specifies the length (measures) of
the interval for which the click will
alternate between “Sounding” and
“Quiet.”
Quiet
Of the measures specified by “Measures,” this setting
specifies the length of the measures that will be
“Quiet.”
RANDOM
The length of the Quiet interval
will randomly change each time.
1, 2, 4
Specifies the length (number of
measures) of the Quiet interval.
* This setting cannot be longer
than half of the Measures value.
* You can press the [F3] (CLICK) button to make click settings (p. 17).
WARM UPS
In this mode you’ll successively practice steps 1–3, be graded on your
performance at each step, and then receive a final evaluation.
You can choose one of three courses (5/10/15 minutes), ranging from
easy to difficult. You can also adjust the tempo according to your level
of skill.
MEMO
After starting WARM UPS, you can press the [F5] (PAUSE) button
to pause or resume. While paused, you can press the [F4] (STOP)
button to stop.
1 . In the WARM UPS screen, press the [F5] (START) button.
Step 1: Change-Up
In this step, the rhythm type will change every two measures.
Starting from half notes, the note values will gradually become
shorter, and will then return to half notes; this change in rhythms
will be repeated.
Step 2: Auto Up/Down
The tempo will gradually be raised and lowered.
The tempo will increase by 1 BPM (beat-per-minute) for each beat
until the click reaches the upper limit; then the tempo will continue
slowing down by 1 BPM until it reaches the initial tempo. This
repeats when finished.
MEMO
Press the [F4] (SET MAX) button when you practice to set the
current tempo as the maximum. Press [F4] (CLR MAX) to return the
maximum tempo to 260 BPM.
* Auto Up/Down will be executed if Duration is 10 MINS or 15 MINS.
* You cannot change the current tempo when using Auto Up/Down.
* The current tempo value will be the lower tempo limit.
Step 3:Time Check
At this step, the accuracy of your playing will be checked against
the click. You can see in the screen if you are ahead, behind or on
the beat.