Roland TD-50X Prismatic V-Drums Sound Module - Manual (Page 13)

13
Getting Ready
Making the Power Automatically Turn Off
After a Time
(AUTO OFF)
The power to this unit will be turned off automatically after
a predetermined amount of time has passed since it was
last used for playing music, or its buttons or controls were
operated (Auto Off function).
If you do not want the power to be turned off automatically, disengage
the Auto Off function.
* To restore power, turn the power on again (p. 12).
1 . Press the [SETUP] button.
2 . Use the PAGE [UP] [DOWN] and function buttons to
select “AUTO OFF.”
The AUTO OFF screen appears.
3 . Use the [-] [+] buttons or the dial to set the Auto Off
function.
Value Explanation
OFF The power does not turn off automatically.
4 HOURS
When four hours have elapsed without
any pad being struck or any operation
being performed, the unit will turn off
automatically.
4 . Press the [KIT] button to return to the DRUM KIT screen.
MEMO
If the AUTO OFF function is set to “4 HOURS,” the message
“WARNING: AUTO OFF, The TD-50X will turn off in 30 min.” appears
30 minutes before the power turns off.
Making Hi-Hat Settings
When using the VH-14D digital V-hi-hat or the VH-13, VH-11 or VH-10
V-hi-hats, adjust the offset on the TD-50X.
This is necessary in order to correctly detect open/close operations
and pedal movement.
Settings for the VH-14D
1 . Press the [TRIGGER] button.
2 . Press the PAGE [UP] button several times to display the
topmost page.
3 . Press the [F4] (HI-HAT) button.
The TRIGGER HI-HAT screen appears.
* “VH-14D” is not shown as a Trig Type when the VH-14D is not
connected or if it is not assigned as the hi-hat. In this case, connect
the VH-14D and assign it as the hi-hat (p. 12).
4 . Press the [F5] (OFFSET) button.
The VH OFFSET ADJUSTMENT screen appears.
5 . Loosen the clutch screw of the VH-14D and let it sit on
the bottom hi-hat.
* Do NOT touch the hi-hats or the pedal.
Clutch screw
6 . Press the [F5] (EXECUTE) button.
The “VH Offset” parameter is set automatically (approx. 3 seconds).
The [TRIGGER] button flashes and then remains lit.
7 . Press the [KIT] button to return to the DRUM KIT screen.
Make detailed adjustments to the parameters as necessary.
& “Data List” (PDF)