Roland TD-50X Prismatic V-Drums Sound Module User Manual
Page 14
14
Getting Ready
MEMO
You can also press the [TRIGGER] button while holding down the
[KIT] button on the TD-50X to adjust the offset.
When first connecting the VH-14D to the drum sound module,
the trigger parameters are set to the recommended values.
The trigger parameters may need to be adjusted depending on
the environment where the VH-14D is used, including how it is
mounted and the position in which it is set up.
&
“Data List” (PDF)
Settings for the VH-13
1 .
Press the [TRIGGER] button.
2 .
Press the PAGE [UP] button several times to display the
topmost page.
3 .
Press the [F4] (HI-HAT) button.
The TRIGGER HI-HAT screen appears.
4 .
Use the [-] [+] buttons or the dial to set Trig Type to
“VH13.”
5 .
Press the [F5] (OFFSET) button.
The VH OFFSET ADJUSTMENT screen appears.
6 .
Loosen the clutch screw of the VH-13 and let it sit on
the bottom hi-hat.
* Do NOT touch the hi-hats or the pedal.
7 .
Press the [F5] (EXECUTE) button.
The “VH Offset” parameter is set automatically (approx. 3 seconds).
The [TRIGGER] button flashes and then remains lit.
8 .
Press the [KIT] button to return to the DRUM KIT screen.
Make detailed adjustments to the parameters as necessary.
&
“Data List” (PDF)
Configuring the VH-11
(or VH-10)
This shows how to configure the VH-11. The steps are the same for the
VH-10, with only the model name being different.
1 .
With the hi-hat completely separated from the motion
sensor unit, power-on the TD-50X.
2 .
Loosen the clutch screw of the VH-11, so that the hi-hat
naturally rests atop the motion sensor unit.
3 .
Press the [TRIGGER] button.
4 .
Press the PAGE [UP] button several times to display the
topmost page.
5 .
Press the [F4] (HI-HAT) button.
6 .
Use the [-] [+] buttons or the dial to set Trig Type to
“VH11.”
7 .
Turn the VH offset adjustment screw on the VH-11 while
watching the meter on the right side of the TD-50X’s
screen.
Adjust the offset so that the
appear in the meter.
8 .
Press the [KIT] button to return to the DRUM KIT screen.
Make detailed adjustments to the parameters as necessary.
&
“Data List” (PDF)