PLANET MGSW-28240F - Manual (Page 287)

Command Guide of MGSW-28240F
Usage Guide:
To configure the timeout of Radius-Server
Example:
To configure the timeout (10) of Radius-Server
Switch# configure terminal
Switch (config)# radius-server timeout 10
4.2.189 rmon alarm
Command:
rmon alarm { | {{ ifInOctets | ifInUcastPkts | ifInNUcastPkts |
ifInDiscards | ifInErrors | ifInUnknownProtos | ifOutOctets | ifOutUcastPkts |
ifOutNUcastPkts | ifOutDiscards | ifOutErrors } }}
{ absolute | delta } rising-threshold
[] falling-threshold
-2147483648-2147483647> [ ] { [ rising | falling |
both ] }
rmon Remote Monitoring
alarm Configure an RMON alarm
MIB object to monitor
ifInDiscards The number of inbound packets that are discarded even the packets are
normal
ifInErrors The number of inbound packets that contained errors preventing them from
being deliverable to a higher-layer protocol
ifInNUcastPkts The number of broad-cast and multi-cast packets delivered to a
higher-layer protocol
ifInOctets The total number of octets received on the interface, including framing
characters
ifInUcastPkts The number of uni-cast packets delivered to a higher-layer protocol
ifInUnknownProtos The number of the inbound packets that were discarded because of
the unknown or un-support protocol
ifOutDiscards The number of outbound packets that are discarded event the packets is
normal
ifOutErrors The The number of outbound packets that could not be transmitted
because of errors
-287-