PLANET MGSW-28240F - Manual (Page 248)

Command Guide of MGSW-28240F
Example:
To set Mirroring Port (GigabitEthernet 1/2)
Switch# configure terminal
Switch (config)# monitor destination interface GigabitEthernet 1/2
4.2.139 monitor source
Command:
monitor source interface * | 10GigabitEthernet | GigabitEthernet
{ both | rx | tx }
monitor Set monitor configuration
source The source port(s). That is the ports to be mirrored to the destination port.
Default:
Disabled
Usage Guide:
To configure Mirrored Port
Example:
To set Mirrored Port (GigabitEthernet 1/1, Tx + Rx)
Switch# configure terminal
Switch (config)# monitor source interface GigabitEthernet 1/1 both
4.2.140 mvr
Command:
mvr
mvr Multicast VLAN Registration configuration
Default:
Disabled
Usage Guide:
To enable MVR
-248-