PLANET MGSW-28240F - Manual (Page 240)

Command Guide of MGSW-28240F
Switch# configure terminal
Switch (config)# mep 2 level 2
4.2.128 mep lm
Command:
mep lm [ multi | uni ] [ single | dual ] [ fr10s | fr1s | fr6m | fr1m |
fr6h ] [ flr ]
mep Maintenance Entity Point
The MEP instance number.
lm Loss Measurement
Priority in case of tagged OAM. In the EVC domain this is the COS-ID.
fr10s Frame rate is 10 f/s.
fr1m Frame rate is 1 f/min.
fr1s Frame rate is 1 f/s.
fr6h Frame rate is 6 f/hour.
fr6m Frame rate is 6 f/min.
dual Dual ended LM is based on CCM PDU.
single Single ended LM is based on LMM/LMR PDU.
multi OAM PDU is transmitted with multicast MAC.
uni OAM PDU is transmitted with unicast MAC. The MAC is taken from peer MEP MAC database. In case of LM
there is only one peer MEP.
flr The Frame Loss Ratio interval.
The Frame Loss Ratio interval value.
Default:
Usage Guide:
To configure Loss Measurement of MEP.
Example:
To configure Loss Measurement of MEP 2 as below table
-240-