Avago Technologies MegaRAID SCSI 320-0 (520-0 CH) - Manual (Page 92)

4-34 Installing and Configuring Clusters
Copyright © 2003-2008 by LSI Corporation. All rights reserved.
4.7.16 Configuring the Second Node
For this procedure, have node one and all shared disks powered on, then
power up the second node.
Installation of Cluster Service on the second node takes less time than
on the first node. Setup configures the Cluster Service network settings
on the second node based on the configuration of the first node.
Installation of Cluster Service on the second node begins the same way
as installation on the first node. The first node must be running during
installation of the second node.
Follow the same procedures used to install Cluster Service on the first
node, with the following differences:
Step 1. In the Create or Join a Cluster dialog box, select The Second
or Next Node in the Cluster, then click Next.
Step 2. Enter the cluster name that was previously created (in this
example, ClusterOne) and click Next.
Step 3. Leave Connect to Cluster as unselected.
The Cluster Service Configuration Wizard automatically
supplies the name of the user account selected when you
installed the first node. Always use the same account you used
when you set up the first cluster node.
Step 4. Enter the password for the account (if there is one), then
click Next.
Step 5. At the next dialog box, click Finish to complete configuration.
The Cluster Service starts.
Step 6. Click OK.
Step 7. Close Add/Remove Programs.
Step 8. If you install additional nodes, repeat the preceding steps to
install Cluster Service on all other nodes.