Avago Technologies MegaRAID SCSI 320-0 (520-0 CH) - Manual (Page 100)

4-42 Installing and Configuring Clusters
Copyright © 2003-2008 by LSI Corporation. All rights reserved.
Figure 4.20 Select Partition Type Screen
Step 6. Select Primary Partition, then click Next.
The Specify Partition Size screen displays.
Step 7. On the Specify Partition Size screen, select a full partition size,
if desired, then click Next.
The next screen that displays is used to assign the drive letter
or path.
Step 8. Assign a drive letter and click Next.
The Format Partition screen displays next.
Step 9. On the Format Partition screen, select to format the partition,
set the volume label, and click Next.
The final Wizard screen displays, as shown in Figure 4.21 . This
screen displays the settings that you selected.