Avago Technologies MegaRAID SCSI 320-0 (520-0 CH) User Manual
Page 64
4-6
Installing and Configuring Clusters
Copyright © 2003-2008 by LSI Corporation. All rights reserved.
4.5
Installing the Peer Processor Device in a Windows
Cluster
Use the procedure in this section to install the peer processor device in
a Windows cluster.
Note:
These steps apply to both Windows 2000 and
Windows Server 2003 clusters.
After the shared drives are configured, and both nodes powered up, a
prompt for another device to be installed appears. This is the peer
controller’s initiator ID and is installed as the processor device. The peer
processor device for the 320-2 controller is detected as LSI SCSI 320-2.
The 320-2X and 320-4X controllers peer processor device are detected
as 320-2X SCSI Processor Device and 320-4X SCSI Processor Device.
Perform the following steps to correctly install the driver for this device so
that the prompt does not display anymore.
Step 1.
Using the MegaRAID SCSI 320-2 controller as an example, in
Windows Server 2003, when the peer initiator ID is detected,
the New Hardware Wizard detects the peer initiator as
LSI SCSI 320-2.
The peer initiator in this example, LSI SCSI 320-2, is shown in
.