Avago Technologies MegaRAID SCSI 320-0 (520-0 CH) - Manual (Page 46)

3-6 MegaRAID 320 Storage Adapter Characteristics
Copyright © 2003-2008 by LSI Corporation. All rights reserved.
Figure 3.3 MegaRAID 320-2E Card Layout
J17 Termination Power
Enable Channel 0 2-pin header Jumpered: TERMPWR is enabled from the
PCI bus. (default)
No jumper: TERMPWR is enabled from the
SCSI bus. (Refer to J4 and J5)
J18 Termination Power
Enable Channel 1 2-pin header
J20 Control Related to RUBI 3-pin connector Reserved for LSI Logic internal use
J21 RUBI PCI Interrupts
Steering Interface 3-pin connector
Reserved for LSI Logic internal use
J24 RUBI PCI Interrupts
Steering Interface 3-pin connector
J22 Load Sharing Enable 2-pin connector Reserved for LSI Logic internal use
J23 EEPROM Access
Connector 2-pin connector Reserved for LSI Logic internal use
1. The battery connector is not shipped connected. It is recommended that you connect the cable on
the battery pack to J10 before you install the card.
Table 3.2 MegaRAID 320-2 Headers and Connectors (Cont.)
Connector Description Type Comments
J12 Channel 0
External
Very
68-Pin SCSI
Connector
High-Density
J 14 Channel 1
External
Very
68-pin SCSI
Connector
High-Density
J1 J2 J3
J4
J7
J6
J15
J16
J11
Internal High-Density
68-Pin SCSI Connector
Internal High-Density
68-Pin SCSI Connector
J5
J9 Ch 0 Int J10 Ch1 Int
U8