Avago Technologies MegaRAID SCSI 320-0 (520-0 CH) - Manual (Page 26)

2-2 Hardware Installation
Copyright © 2003-2008 by LSI Corporation. All rights reserved.
2.2 Quick Installation
The following steps are for quick Storage Adapter installation. These
steps are for experienced computer users/installers.
Section 2.3,
“Detailed Installation,” contains the steps for all others to follow.
Step 1. Turn power off to the server and all hard disk drives,
enclosures, and system components and remove the PC power
cord.
Step 2. Open the cabinet of the host system by following the
instructions in the host system technical documentation.
Step 3. Determine the SCSI ID and SCSI termination requirements.
Step 4. Install the MegaRAID 320 Storage Adapter in the server,
connect SCSI devices to it, and set termination correctly on the
SCSI channel(s). Ensure that the SCSI cables you use conform
to all SCSI specifications.
Step 5. Perform a safety check.
– Ensure that all cables are properly attached.
– Ensure that the MegaRAID 320 Storage Adapter is
properly installed.
– Close the cabinet of the host system.
Step 6. Turn power on after completing the safety check.