Network connections dialog box – Avago Technologies MegaRAID SCSI 320-0 (520-0 CH) User Manual
Page 88
4-30
Installing and Configuring Clusters
Copyright © 2003-2008 by LSI Corporation. All rights reserved.
The order in which the Cluster Service Configuration Wizard
presents these networks can vary. In this example, the public
network is presented first.
Step 3.
Verify that the network name and IP address correspond to the
network interface for the public network.
Step 4.
Select Enable This Network for Cluster Use.
Step 5.
Select the option All Communications (Mixed Network) and
click Next.
The next dialog box configures the private network, as shown
in
. Make sure that the network name and IP
address correspond to the network interface used for the
private network.
Figure 4.12 Network Connections Dialog Box
Step 6.
Select Enable This Network For Cluster Use.
Step 7.
Select the option Internal Cluster Communications Only
(Private Network), then click Next.
In this example, both networks are configured so that they can
be used for internal cluster communication. The next dialog
window offers an option to modify the order in which the