Solare Datensysteme Solar-Log - Manual (Page 101)

101
Operating the Solar-Log 500 and 1000 via the Display
5�5�3 Handling Alarm Notifications
You can acknowledge fault notifications in this menu.
Tap your finger on the display again.
•
The main navigation screen is displayed.
Tap on Diagnosis and then on Alarm Contact.
•
The alarm monitoring status is displayed.
Fig.: Alarm contact
Tap on Acknowledge Alarm Manually .
•
The alarm notification stops.
After the fault has been resolved, tap on Reset Alarm.
•
This resumes the operating mode.
Tap on Menu .
•
The main navigation screen is displayed.
5�5�4 Optimizing the consumption of self-produced power
To specifically concentrate your power consumption at times
when there is sufficient power production, the
Solar-Log 1000 offers the option to automatically turn on and off up to 10 appliances as needed. The appli-
ances are displayed as "Switches" on the display.
The control of the devices is based on the current power surplus, e.g. "production minus consumption." If
no consumption meters are connected, the management is based purely on the power production values.
Note !
Refer to the Installation Manual for the switch settings or contact your installer.