Rugged Cams Rugged Vision DVR - Manual (Page 56)

Camera
Under Camera settings, you can indicate
which camera is a PTZ camera. For PTZ
cameras, you must indicate the communi-
cation protocol used by it.
Procedure Using the Remote Controller or Control Panel:
1. In SETUP, select PTZ->Camera.
2. In PTZ Camera Setup, use [UP],
[DOWN], [LEFT] or [RIGHT] to navigate
through the menu.
3. Use [ENTER], [SELECT], [+] or
[-] to change the values. If the status is
checked, the camera is a PTZ camera. The
protocol may either be Pelco-D, Pelco-P,
DynaColor, Merit Li-Lin, Sony Visca. Note
that all changes you make are always
saved.
4. When you are done, press
[SETUP] or [BACK].
PTZ Speed
You may adjust the panning/tilting speed,
zooming speed and focusing speed of your
PTZ camera. Note, however, that not all
PTZ cameras have all 3 speed controls.
Check your PTZ camera manual to verify.
Procedure Using the Remote Controller or Control Panel:
1. In SETUP, select PTZ->Speed.
2. In PTZ Speed Setup, use [UP] or
[DOWN] to navigate through the menu.
3. Use [LEFT], [RIGHT], [+] or [-] to
change the values.
4. Press [ENTER] or [SELECT] to save and exit. Or, press [SETUP] or [BACK] to exit without saving.
56