Rugged Cams Rugged Vision DVR - Manual (Page 29)

Event Search
Procedure Using the Remote Controller or Control Panel:
1. Under SEARCH and PLAYBACK, select
Event Search by pressing on
[ENTER] or [SELECT].
2. Under Event Search, press [UP] or
[DOWN] to select option that you want to
change. For instance, if you want to edit day,
simply press [DOWN] until you highlight the
Day option.
3. Press [LEFT], [RIGHT], [+] or [-] to change
the values of the given option.
4. Press [ENTER] or [SELECT] to run search. If there are no recorded videos,
repeat steps 2 to 5. You will then be taken to a screen, displaying your search
results.
5. Select the video that you want to playback by pressing [UP] or [DOWN] and press [ENTER] or
[SELECT] to view recorded video.
6. Press [LEFT] or [RIGHT] to move from previous or next pages.
NOTE: Up to a maximum of 10 recorded videos will be displayed per page.
Smart Search
Legend:
1. Red – indicates that there is an event on the
specific field
2. White – indicates current selected field or
current selection
3. Blue – indicates cursor pointer position
Procedure Using the Remote Controller or
Control Panel:
1. Under Smart Search, press on [LEFT], [RIGHT], [+] or [-] to select camera, and then press [DOWN].
2. Use [LEFT], [RIGHT], [+] or [-] to select event type. You may choose from ALL, FORCED, SENSOR,
MOTION, AUDIO, EVENT or CONTINUOUS. Then, press [DOWN].
3. Select week by pressing [LEFT] or [RIGHT]. If you see red markings, that means there are recordings
on that particular period. Then press [DOWN] to go to next options.
4. Select date, hour and minute by pressing [LEFT] or [RIGHT]. You may also Press [UP] or [DOWN] to
move among options.
5. Then press [ENTER] or [SELECT] to playback video. If there’s more than one video, choose from the
results by pressing [UP] or [DOWN] and then press [ENTER] or [SELECT] to play recorded video.
29